INTAKE HOPPER PS220 - KP

Intake intake hopper produced by BIN is a part of PS220 screw auger conveyors system . It is a basic device in an intake station for grain, maize and oily seeds. It is designed to provide intake of the material from trailers, semi trailers and from loading platforms. Material can be transported with screw auger conveyors, bucket elevators etc. to warehouses, silos, and other places for grain and seed storage. It is particularly suitable for intake stations to BIN silos. A body of the intake hopper is made of galvanized iron. In its lower part there is a place to connect PS220 screw auger conveyor, to which another screw auger conveyor or bucket elevator or another device for grain transport can be connected. In the upper part of the body there is a grate with rims above its surface. The quantity of grain is regulated with a latch with a control lever.

Construction and product destination

The intake hopper has a module structure:

• PS220-KP-3.0- intake hopper module, 3m length, without the driving set
• PS220-KP-AKC- the intake hopper’s accessories

The hopper also consists of PS220 screw conveyors, which allow transportation and unloading of the crop from the intake hopper:

• PS220-P1.0, PS220-P1.5, PS220-P2.5, PS220-P3.0- screw conveyors’ extensions
• PS220-N3/200, PS220-N4/200 – screw conveyors drives
• PSU220-I/O-200- the load/unload of the PS220 screw conveyors
• PS220-LOZ/P1-  the polyamide bearing connecting the screw conveyors’ extensions
• MOCRUR200- the mounting of the screw conveyor pipes

When using PS220-KP-AKC with one, two, or three PS220-KP-3.0 modules results in acquiring a 3m, 6m or 9m length intake hopper.

General view:

To ensure the proper grain reception, the intake hopper must be installed on a foundation.

The BIN intake hopper consists of the following modules:

• The KP185-3 basic module of length of 3m and width of 1.85 cm
• The KP185-P3 intake hopper extension of length of 3m and width of 1.85 cm